Image acquisition
•If you increase the exposure time so that the frame rate drops, a single image can be defective.
•To achieve the maximum frame rate, you must set DeviceLinkThroughputLimit to the maximum value.
•To achieve the minimum exposure time, you must set DeviceLinkThroughputLimit to the maximum value.
•To achieve the maximum exposure time, you must set DeviceLinkThroughputLimit to the minimum value.
•As the models do not have an image memory, images may be lost under certain circumstances. In this case, reduce the value of DeviceLinkThroughputLimit. Note, however, that this lowers the frame rate and may cause a rolling shutter effect.
Gain
•The default settings for gain are optimized for color cameras with HQ filter. For proper color rendition, if a color model is used without HQ filter, lenses should be used that include a HQ-type filter element (IR-cut filter, also known as "hot mirror", with a cut-off wavelength at approx. 650 nm).
ROI
•The frame rate does not increase by the use of a horizontal ROI.
Binning
•Sensor binning is only supported by monochrome sensors.
Decimation
•Sensor decimation is only supported by color sensors.
HDR
•In QuadHDR mode, a maximum exposure time of 3 ms is recommended for the longest exposure of a pixel. Otherwise, this may result in increased hot pixel formation in the HDR image.
USB 3 uEye+ XCP Rev. 1.2/USB 3 uEye+ XLS Rev. 1.2
The model does not support the following features:
•Automatic exposure (ExposureAuto)
Alternatively, you can perform auto exposure on the host with IDS peak comfortSDK or you can use the auto functions in IDS peak genericSDK.
•Automatic gain (GainAuto)
Alternatively, you can perform the gain functions on the host with IDS peak comfortSDK or you can use the auto functions in IDS peak genericSDK.
•Automatic white balance (BalanceWhiteAuto)
Alternatively, you can perform the automatic white balance on the host with IDS peak comfortSDK or you can use the auto functions in IDS peak genericSDK.
•Chunks (ChunkDataControl)
•Counter and timer (CounterAndTimerControl)
•Events (EventControl)
•Color correction (ColorCorectionMode)
Alternatively, you can perform color correction on the host.
•FPGA binning (BinningSelector)
Alternatively, you can perform binning on the host.
•FPGA decimation (DecimationSelector)
Alternatively, you can perform decimation the host.
•Gamma (Gamma)
Alternatively, you can perform gamma on the host.
•Line scan mode (SensorOperationMode "Linescan")
•LUT (LUTControl)
•Pulse-width modulation (PWMControl)
•Sequencer (SequencerControl)
USB 2.0 operation
•The camera model does not support USB 2.0 operation.
