IDS peak 2.8.0 / uEye+ firmware 3.33
|
This function is supported by the following models: U3 models •PCB version uEye+ LE USB 3.1 Rev. 1.2 (requires USB3 Vision firmware 3.2 or higher) •uEye+ LE USB 3.1 Rev. 1.2 AF (requires USB3 Vision firmware 3.2 or higher) •USB 3 uEye+ ACP GV models •GigE uEye+ ACP UI models •PCB version uEye LE USB 3.1 Gen 1 •PCB version USB 3 uEye LE •PCB version USB uEye LE •GigE uEye LE |
Controls the I2C acknowledge polling timeout.
Name |
I2CAckPollingTimeout |
Category |
|
Interface |
Integer |
Access |
Read/Write |
Unit |
ms |
Visibility |
Expert |
Values |
1 ... 4000 |
Standard |
IDS |
Availability uEye+ |
|
Availability uEye |
- |
Code example
C++
// Determine the current I2CAckPollingTimeout
int64_t value = nodeMapRemoteDevice->FindNode<peak::core::nodes::IntegerNode>("I2CAckPollingTimeout")->Value();
// Set I2CAckPollingTimeout to 1000
nodeMapRemoteDevice->FindNode<peak::core::nodes::IntegerNode>("I2CAckPollingTimeout")->SetValue(1000);
C#
// Determine the current I2CAckPollingTimeout
long value = nodeMapRemoteDevice.FindNode<peak.core.nodes.IntegerNode>("I2CAckPollingTimeout").Value();
// Set I2CAckPollingTimeout to 1000
nodeMapRemoteDevice.FindNode<peak.core.nodes.IntegerNode>("I2CAckPollingTimeout").SetValue(1000);
Python
# Determine the current I2CAckPollingTimeout (int)
value = nodeMapRemoteDevice.FindNode("I2CAckPollingTimeout").Value()
# Set I2CAckPollingTimeout to 1000 (int)
nodeMapRemoteDevice.FindNode("I2CAckPollingTimeout").SetValue(1000)
